Managed this rig up a homemade induction heater from a 10$ board off amazon +7$ cigarette plug terminal cable

Induction heater is for my dynavap, the commercial ones are quite expensive and I figured it would be a cheap and easy project to make one up

I made a quick YouTube video showing the IH off :)

    • @[email protected]
      link
      fedilink
      55 months ago

      Pepperidge Farm remembers when clever was an apple and a lighter.

      Half of us would die trying to use that, but glory to glorzo if it works for ye but not for me.

      • I pretty much only buy single apples when I am planning to use them as a pipe. That is the best way to smoke a bowl. And if you’re not a scaredy cat, it becomes a baked apple treat when you’re done.

    • @[email protected]OP
      link
      fedilink
      English
      4
      edit-2
      5 months ago

      looks at traditional stoner equipment “We have the technology… We can rebuild them. Make them hit faster, stronger, cleaner.”

  • @[email protected]
    link
    fedilink
    95 months ago

    This post was a journey for me scrolling by.

    Pic: this is drugz?

    Title: this is not drugz

    Sub: this is drugz!

    • @[email protected]OP
      link
      fedilink
      English
      4
      edit-2
      5 months ago

      The board is rated for up to 12v10a so 120 watts. Its able to heat up the dynavap to combusting temps in about 10 seconds so I wouldn’t doubt its able to melt thin wire in short order. For my purposes it’s actually almost too powerful so either need to lower the turns in coil or add a potentiometer on to the circuit